|
Model:
|
Width 8'-6"
|
| |
Axles 5 (3+2) |
| |
Capacity 128,000 lbs. |
| |
Weight 41,500 lbs. |
| |
|
| Front Frame: |
Fabricated special beams with steel rated 100,000 lbs. |
| |
Coupler sections with 5/16" high tensile plate including a fixed H-duty pin on the front extension and a removable pin on the remaining gooseneck. |
| |
Schnable neck with 8'-6" extension raising hydraulically. |
| |
Hydraulic gooseneck with 2 cylinders to raise the neck plus 2 other cylinders to elevate the head. Possible to raise the tower 36" off the ground. |
| |
4 Hook system for fast tower connection. |
| |
The neck will connect to the mid and base tower sections. |
| |
|
| Rear Frame: |
Fabricated "I" beams made with steel rated at 100,000 psi. |
| |
Hydraulic gooseneck with 2 cylinders connected to a heavy duty turn table controlling the hydraulic cyclinders for the steering axles. |
| |
Plastic fenders over each axle. |
| |
Support for jeep over rear axles. |
| |
|
| Suspension: |
Hendrickson HT-250 air ride 60in tridem and 60 in tandem. |
| |
5 axles rated at 25,000 lbs. capacity with D22 spindle end, 77.5" track with dust shield and cam enclosure. |
| |
3 Front axles on a turn table. |
| |
Brake size 16.5"x7" x3/4" non asbestos Q-brake. |
| |
Stemco guardian HP oil seal. |
| |
Stemco cups and bearings. |
| |
Dura light 10 studs steel piloted hubs with cast drum. |
| |
Alcoa aluminum tubeless wheels, 22.5"x8.25" machine finish. |
| |
Tires 275/70R22.5 Michelin XZE2. |
| |
Rockwell wabco brake system comply with FMVSS 121. |
| |
TSE brake chamber maxi 30/30. |
| |
Rockwell automatic slack adjuster. |
| |
Scale-O-Matic liquid fill guage with manual dump valve. |
| |
|
| Hydraulic: |
Hydraulic closed in circuit with 2 seperate circuits for safety purposes to automatically steer the axles. |
| |
2 Power packs with 13 HP Honda motors with pump, reservoirand hydraulic circuit for automatic and manual steer of axles inside a closed and vented aluminum box, one power pack installed onto the rear dolly to control the axles and the rear gooseneck, and one power pack installed onto the front gooseneck. |
| |
Hand held remote control to activate the rear axles from a distance. |
| |
|
| Electrical: |
LED sealed beams installed as per FMVSS 121. |
| |
7-way recepticle with 7 wire main cable. |
| |
Junction box sceptor sealed. |
| |
Removable strobe light. |
| |
|
| Paint: |
100% all steel shot blasted. |
| |
Epoxy primer |
| |
2 coats of urethane paint, non-metallic. |
| |
Standard 55% reflective tape on sides and bumper per regulations. |
| |
|
| Accessories: |
Title holder. |
| |
Steps on curb side |
| |
100' of air and electrical cable supplied for extension. |
| |
Winches plus supports with steel cable and straps to hold the air and electrical cables. |
| |
Removable Wide load sign. |
| |
|
